Title: Mechanical Installation
Introduction
Mechanical installation is the one part of hardware development, it's most complicated to install because it need to relate with electronic design that designed in the previous week. This week, all works that relate with this matter will be discussed and shown clearly.
Objective
1. To complete installation mechanical design of project.
2. To apply the equipment and materials that appropriate with specification of project.
Project Encountered
All works that made is based on the project design and electronic design that has been implemented before. Thus, it does not give any either before, during do this activities. However, this activities is still in progress.
Project Description
The installation mechanical plastic acrylic and wiring for this project is made separately. The following is the procedures to install and wire all the components that used in this project show below :-
Step 1
First, cut acrylic plastic according to the size of the drawing's project.
Figure 1: Cutting the Acrylic plastic.
Step 2
Drill holes in the plastic acrylic by location and mechanical components to be in the stick later on measurements that have been made.
Figure 2: Drill holes of acrylic for mount the components and others mechanical.
Step 3
Third, affix all acrylic plastic cut to size using Styrofoam. All design based on mechanical drawing's.
Figure 3: Affix and design mechanical project.
Step 4
Lastly, try to mounting the components of project.
Figure 4: Mounting the component.
As a conclusion for this activity is not completely done and it will continue for the next week to complete the task.
No comments:
Post a Comment